InsertZ.tml

Converts 2D Sets into Breaklines using spot elevation text

Return to Products Page

InsertZ.tml will:

Quickly place elevations along a set by picking text objects
Takes 2D data and creates a sloping line for a DTM

If you have 2D linework and callout text, you can use Insertz.tml to create 3D points with the elevation of the callout text by selecting the text then the point on the set.

In Terramodel, to accomplish the same task without InsertZ.tml, you will need to convert plines to sets, edit each point of the set and type the elevation (you can't click on text for the elevation without this TML), and then edit sets to insert points where convert didn't create them.

How to use InsertZ.tml

After downloading InsertZ.* to the Terramodel installation folder\Terramodel\tmls folder, open a Terramodel project and type insertz at the command line and press the < enter > key.

You will see the following:

Pick a set or pline. If you select a pline, it will be converted to a set.

Type an elevation or better yet, pick the elevation text, then pick a point or location on the set to assign the selected elevation. If a point already exists at the selected location, the elevation will be assigned. If a location is selected where a point does not exist, a point will be inserted into the set and the elevation will be assigned.

Pick_set_then_pick_text_object_for_elevation_then_location_along_set

Programmer's Note:

Similar to the sloping line command in Sitework.

For more information please call us at (909) 797-9374

Home | Products | Search | Contact

Site Design by: ComputerJohn.com